Having trouble with your washing machine? A self-diagnosis system will help to deal with them.
Electronically controlled Westell washing machines show an error code on the display. Electromechanical AGRs give an error by flashing indicators with interruptions. For example, the E02 code can be defined as follows: the lamp blinked twice, pause, blink again.
Fault codes specific to Vestel CM
The table shows the error values. Now you will learn how to fix the problem with your own hands.
Error code on the scoreboard | Panel Indication | Value | Reasons for the appearance | How to fix the problem |
E01 | With error E01, the 1st and 2nd lamps flash. | Loose hatch door. |
| What to do:
|
E02 | Code E02: the 1st and 3rd indicators blink. | There is no water in the tank, or it has not reached the lowest possible level. | If the code is displayed on the washer board, then:
| How to fix a breakdown:
|
E03 | The 1st and 4th light flashes on the panel. | Error in the pump. | Why code E03 is on:
| How can I remove the error with my own hands:
|
E04 | The 2nd and 3rd indicators blink. | What does the combination mean: overflow of water. | If the error code E04 is displayed on the CMA, there is too much water in the tank. | The system should automatically drain excess water. |
E05 | How to recognize the E05 code: the lamps under numbers 2 and 4 flash. | Faulty heating element or thermistor. | The heater of the Westell washing machine burned or was damaged by scale. | To reset the error, do this:
|
E06 | Error indication E06: 3rd and 4th lights flash. | Malfunction in the motor. | The cause of the malfunction is a breakdown of the motor or its components. | To solve the problem, it is necessary to replace the electric motor brushes or install a new engine. |
E07 | Code E07 appears as follows: the 1st, 2nd, 3rd indicators blink. | What does the error mean: malfunction of the electronic control unit. | If the Vestel washing machine gives this error code, there are problems with the control board. | How can I fix a breakdown:
|
E08 | In case of malfunction E08, the 2nd, 3rd and 4th bulbs flash. | The SM electric motor is out of order. | Motor defective. | Checking and changing the engine of a Westell washing machine. |
E09 | How to recognize code E09: 1st, 2nd, 4th lamps blink on the panel. | Error in the power supply. | The cause of the problem: the voltage in the network is not normal. | Too high or low voltage will not allow the AGR to work normally. It is necessary to wait for the voltage to normalize or to call an electrician. |
E10 | With error E10, the 1st, 3rd, 4th bulbs blink. | Communication problems. | There are problems with the communication system. | Reboot the washing machine for 15-20 minutes. If, when switching on again, a malfunction is displayed again, it is better to turn off the water supply and call the wizard. |
Having familiarized yourself with typical breakdowns of Westell washing machines, you can solve the problem yourself or contact a service center.